Best Background Checked Fence Installation Contractors in Los Angeles, CA

Use this hub as your shortcut to the four key decision pages for background checked fence installation contractors in Los Angeles, CA.

Cost Summary

Get local pricing ranges, what affects total cost, and when higher quotes are justified. Open cost guide.

How-To-Choose Summary

Use a practical hiring checklist, key interview questions, and red flags to avoid before signing. Open hiring guide.

Contractors Summary

Compare provider types, credentials, scope quality, and quote transparency side by side. Open contractors page.

Financing Summary

Review payment paths, deductible math, financing options, and how to choose the lowest-risk payment route. Open financing page.

How much does fence installation cost in Los Angeles?

Fence installation in LA typically runs $16–$90+ per linear foot installed, depending on material, site conditions, and fire zone requirements. Chain-link runs $16–$30/lft; wood privacy (cedar or redwood) runs $32–$65/lft; wrought iron or steel runs $80–$180/lft. A 100-linear-foot project ranges from $1,600 to $18,000+ for masonry or VHFHSZ-compliant steel fencing. Hillside properties (Silver Lake, Hollywood Hills, Topanga) typically carry a site access surcharge of $500–$1,500 above base pricing.

Do I need a permit to install a fence in Los Angeles?

In most standard residential zones, a permit is not required for:

• Wood or vinyl privacy fencing up to 6 feet in rear/side yards
• Fences up to 42 inches in front yards (R1 zoning)

Permits are required for:

• Any fence or wall over 8 feet in height
• Any masonry or concrete block wall regardless of height
• Fences requiring grading or structural footings on hillside lots

Check with the LA Department of Building and Safety (LADBS) if you are unsure of your zone's requirements before starting any work.

Does my LA property fall in a fire hazard zone?

You can check your property's Fire Hazard Severity Zone designation using the CalFire FHSZ viewer or the LA County GIS fire hazard map. Properties in Very High Fire Hazard Severity Zones (VHFHSZ) — which include large portions of Pacific Palisades, Brentwood, Topanga, Altadena, Sylmar, Granada Hills, and hillside areas of the Hollywood Hills — are subject to CBC Section 705A restrictions on combustible fencing within 100 feet of the structure. Wood fencing in these zones may be non-compliant.

What CSLB license should my fence contractor have?

For fence installation specifically, look for a California CSLB C-13 (Fencing) license. A Class B (General Building) contractor may also legally install fences as part of a broader project scope. Verify any license at cslb.ca.gov/OnlineServices/CheckLicenseII — confirm the license is active, bonded, and shows no disciplinary actions. Any fence contractor quoting work over $500 in California must be CSLB-licensed.

Can I install a wood fence in the Hollywood Hills or Pacific Palisades?

It depends on exactly where on the property and whether it falls within 100 feet of the habitable structure. In VHFHSZ-designated areas, CBC Section 705A restricts combustible materials within 100 feet of a structure. Wood fencing at the rear or sides of the lot beyond 100 feet from the house may still comply in some configurations; however, after the January 2025 Palisades Fire, the LA Fire Department is actively enforcing CBC 705A in VHFHSZ areas. A licensed fence contractor familiar with WUI (Wildland-Urban Interface) requirements is essential for properties in these neighborhoods.

Do I need to call 811 before installing a fence in Los Angeles?

Yes. Call 811 (or visit digalert.org) at least 3 business days before any excavation in California — the state mandates 3 working days' notice (not 2 like many other states). SoCal Gas, So Cal Edison, AT&T, and water utility lines run through residential properties across LA. In hillside neighborhoods, utilities are sometimes closer to the surface than expected. An unmarked gas line struck during post augering is a life-safety emergency.

How do I handle a fence on the property line with my neighbor?

California Civil Code §841 (the "Good Neighbor Fence Law") allows either neighbor to request that the other share equally in the cost of a reasonable fence on the shared property line, provided 30 days' written notice is given. If your neighbor refuses to share costs, you may still build the fence — but must not encroach on their property. Before any installation, confirm your property line using your deed survey or a licensed land surveyor. LA property line disputes are common and costly; a fence installed 6 inches over the line can require court-ordered removal.